We recently upgraded from 4.6b to ERP6. I have a BDC that fails in ERP6 so I am trying to rework it. Something odd is happening. I find that some BDCs run through find in A-mode while you're stepping through them but not in N-mode when it's hands-off.
Here's the really odd thing. I have re-recorded a BDC against tran CO01 that creates a PP work order. I take the recording and product a function. I test the function with all of the default values intact accept for the new work order# and the function runs in A-mode. It FAILs in N-mode. It appears that ERP6 cannot run it's own BDC recordings.
I notice in A-mode that there are sometimes green info messages on the status line. What I'm wondering is if these are ok in A-mode because I can hit enter and move on vs. N-mode that perhaps gets stuck on them. I say that because I have seen BDCs fail and report in the MSGTAB information messages as though this is what caused the transaction to fail.
Is there some config setting in ERP6 that tells BDCs globally not to fail because of informational status messages?
Thank you.
Crew