on 02-26-2009 12:41 PM
Hello,
I have a requirement where I need to populate the Material Documents (Drawings) in the Document Overview of the Production Order while creating using tcode CO01. I was able to populate the document for the header material but not able to find ways to populate Material Documents (Drawings) for the component materials.
Please let me know if there is any configuration settings for this or is there any Userexits??
Thanks in advance,
Ravi
Hello Ravikumar
From your question it seems that you are able to see documets attached to header material.
Let me explain you
PO 10000493
Material
Line Item Material Document No Doc Type
10 MAT001 DOC001 DRW
20 MAT002 DOC002 DRW
30 MAT003 DOC003 DRW
You said that you are able to view DOC001. Am I right ?
Now Please Check whether you have linked the Documents created DOC002 & DOC003 respectively to MAT002 & MAT003 in Document Info Record in bject link tab.If you have not done this you will not see the documets in PO.
You will have to seleeted the line item and the clip symbol button to view document.
If info found usefull please grant me points
With warm regards
Mangesh Pande
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Please explain how u were able to attach Drawings to the Header Material..??
If you are attaching materials from Document Info Record, then you have to attach the Material Code in Object Linking tab while using cv01n.
Otherwise if u need to attach drawings to component materials - go to MM02 and select the material component.. Go to Addtional data at right hand side-> go to Document data-> select Document..
Object linking for MARA should be enabled for the document type u going to link
Regards
Aby
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
98 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.