Release Code and Strategy

[Former Member]

Hi,

We have created a new release code and its corresponding release strategy. But when we are trying to release the PO, the PO goes to a release code not maintained in the system. What could possibly be lacking in my config?

Scenario : I created release code T1 but the PO goes to release code F2 (which is not configured in the system). Please help.

[Former Member]

Hello ,

Goto CL24N and remove the unwanted.

Later trying creating the PO , I hope this will work.

Regards

Ramesh

[Former Member]

Hi Ramesh,

As you advised, i accessed CL24N to remove the unwanted. Unfortunately, i cannot do so because the system prompted this message "Object not found". What shall I do next?

[Former Member]

Hi,

Delete all the release codes and release strategy maintained in the system.

After deleting pl Save it.

Now you create your release codes and maintain release strategy again.

Def now it will work.

Uts

Award if helpfull

[Former Member]

Hi Jacquiline,

The previous strategies were not deleted , therefore the error.

You can find the previous strategies in the customising for MM under Check Release Strategies.

The solution would be re-create the old strategy . Goto CL24N delete the unwanted and then delete the Strategy . I hope this solution will work out .

Regards

Ramesh

[Former Member]

Hi,

It happens some time , it is taking default values.

I will suggest you to delete all the release codes and release strategy maintained in the system.

After deleting pl Save it.

Now you create your release codes and maintain release strategy again.

Def now it will work.

Uts

Award if helpfull

[former_member581212]

hi,

You shd check your prerequisites maintained for your release strategy..

Hope it helps.

Regards

Priyanka.P

[Former Member]

Release prerequisite is T1 only.

[former_member581212]

hi,

release depends on the Document type and the release strategy...So, is there any exsisting strategy for the same document type which you are using...If yes, then you have to first remove it and then only it'll work..

Hope it helps..

Regards

Priyanka.P