Skip to Content
0
Former Member
Feb 24, 2009 at 06:19 AM

Dynamic Configuratin Bean Not working in PI 7.0 (SP 9)

24 Views

Hi Team,

I am working on a simple scenario HTTP to File (in PI7.0 & SP 9) to check the Dynamic Configuration Bean usage with no success. i.e., I am not seeing any file in receiver folder.

-


File Adapter Channel error from RWB:----


Could not process due to error: com.sap.aii.adapter.file.configuration.DynamicConfigurationException: The Adapter Message Property 'FileName' was configured as mandatory element, but was not supplied in the XI Message header

-


File Adapter Channel error from RWB:----


The above error is obvious since either DCBean module is not at all working or it is not able to set the specified key value pairs in the module configuration. Check below for the module Configuration.

However, the same scenario (by importing .TPZ file) I have configured in XI 3.0 & SP 19 and surprisingly I am able to see the file being created in receiver folder.

The following parameters are used for module configuration under Receiver File Adapter --> Module TAB.

Processing Sequence

1	AF_Modules/DynamicConfigurationBean	Local Enterprise Bean	1
2	CallSapAdapter                          Local Enterprise Bean	0


Module Configuration

1	key.0	insert http://sap.com/xi/XI/System/File FileName
1	value.0	Hello.xml

Questions:-

1. Does Dynamic Configuration Bean is Applicable to only XI3.0 and it service packs?

2. If so, why SAP has omitted Dynamic Configuration Bean above XI3.0.

Note:- I also tried various possibilities in the module configuration (for the configured scenario in PI 7.0 & SP 9) as per SAP Note 974481 & blog [SAP NetWeaver XI: Variable Substitution with Adapter-Specific Message Attributes via DynamicConfigurationBean|https://www.sdn.sap.com/irj/scn/weblogs?blog=/pub/wlg/6400] [original link is broken] [original link is broken] [original link is broken];, but with no success.

Awaiting for the proper replies.........................

Best Regards,

- Gujjeti.