Skip to Content
0
Former Member
Feb 21, 2009 at 12:57 PM

RFC connections to SAPNet - R/3 Frontend fail in setup wizard

35 Views

Hi

I'm trying to setup my IDES to connect to SAP so I can use maintenance optimizer etc. Is that possible using a dynamic IP? (I don't boot much so I could change the settings if the IP changes, but it is an 192.168.1.* address that I get from my ISP using DHCP).

Also. is it neccesary to setup an saprouter? There's no firewall active as security isn't much of an issue for this system. I found a setup guide that's split in two, with or without saprouter, but there's not a lot information on how to do this without that saprouter,

Re

Dennis

Edited by: Dennis Gundersen on Feb 21, 2009 1:57 PM