Skip to Content
0
Former Member
Feb 20, 2009 at 05:05 PM

quota scenario

47 Views

According to the requiremnet of the client i configured as follows

Quotas:

set base entitlement

1 case ..27 vacation quota , rule for base entitlement 001, 0-5 years seniority

27 vacation quota, rule for base entitlement 002 5-10 years seniorty

I dint use sequential numbers because i wanted to give max entitlement in both the above cases. So if i do it like this....then in generation rules i can create two selection rules and put max entitlement for bothe of these .

Everything is fine,.... EXCEPT, that my quota forward rule stoped wotking after i did this. I checked again and defined seniorities on basis of sequentil number again, for eg

2 nd case ....27 vac quota, rule for base ent. 001 sequential number 001 0-5 years seniority

27 vac quota , rule for base ent. 001 sequential n. 002 5-10 years exp. this way my quota carry forward rule works fine but where can i put the condition about max entitlement .Because in generation rule for configuration. like this,i just gives me option to put one for both seniorities.. Please advise how can i use first case and make my quota carry forward rule work...or any suggestions will be highly welcome

Thanks

Edited by: Cristy Kasph on Feb 20, 2009 6:06 PM