on 06-27-2018 12:55 AM
Hi Experts,
Am trying to create the supply plan by using the Unified planning area and have created the necessary master data as below and executing the time series Heuristics operator with no results/ shortage at customer. I have updated the "consensus Demand" Key figure at the customer location with demand values across horizon. Kindly advise if am missing any MD configuration or any setting which might cause this?
The network is Customer-> DC->DC-> Factory and the MD maintained is as below:
Location
Customer
Customer Product
Location Product
Source Customer
Source Location
Source Production
Resource
Production Resource
Resource Location
Resource Location Product
Best Regards,
Arun
Hi Arun,
Suggest you to run Check mode to validate master data consistency. I assume quotas are not setup correctly to flow the demand.
Thanks,
Rohit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Arun
1 thing that I see missing is the MDT ( Production Source Item ).
Assuming that you are not interested in generating dependent demand for component SKU's in that case, have you maintained the source type in Production Source Header MDT as U or P ?
Also can you share the log of the heuristic ?
Regards
Ayan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Arun,
Unified planning area configuration should work properly. I would suggest checking the master data files once again with sources and run the supply operator. Please share your operator error or information log.
Best Regards,
Lingaiah
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Arun, not sure if you still have the issue - best is to pull the business log and see what happened (or messages issued) when the algorithm ran.
Thanks,
Uthaman
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I see subnetwork missing, did you maintain subnetwork master data and also it's value in the prod/loc master data file?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Arun,
Pull "Dependent Demand" KF into planning view and check if you see any value. If there is no value then it means, demand has not propagated to DC/plant level which means there is a problem in master data. Check MD files. Make sure you maintain UOM conversion entries too. System may be generating values but you are not able to view them as conversions values are missing.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
6 | |
4 | |
4 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.