Skip to Content
0
Former Member
Feb 18, 2009 at 09:32 AM

PO taking lot of time to save / generate.

186 Views

Hi Guys,

  • I'm trying to create a new PO in my Quality ECC 6.0 system. The PO gets generated successfully and the Spool is also generated for the same, but the problem is that it was taking around 20 minutes earlier to save the PO ( Purchase order ).

  • Now its taking 5 minutes which is also a lot of time as compared to milli seconds which it should take.

  • There are 2 tables which remain locked till its saved and so we cannot proceed with the subsequent steps with the same PO

  • Please guide me what can be the reason for this and the correct solution to the same.

1. There is one BTC job in Stopped mode for 600118 seconds , could this be a reason.

2. There were around 78 users logged on when I generated the PO, which includes RFC & DIA, Its not many users but could this be a reason?

Please suggest at the earliest if possible how can I reduce this time and what can be the possible reasons for this High response time, my Integration Test is all held up cause of this 😊

Regards,

Nitin