Skip to Content
avatar image
Former Member

PO taking lot of time to save / generate.

Hi Guys,

  • I'm trying to create a new PO in my Quality ECC 6.0 system. The PO gets generated successfully and the Spool is also generated for the same, but the problem is that it was taking around 20 minutes earlier to save the PO ( Purchase order ).

  • Now its taking 5 minutes which is also a lot of time as compared to milli seconds which it should take.

  • There are 2 tables which remain locked till its saved and so we cannot proceed with the subsequent steps with the same PO

  • Please guide me what can be the reason for this and the correct solution to the same.

1. There is one BTC job in Stopped mode for 600118 seconds , could this be a reason.

2. There were around 78 users logged on when I generated the PO, which includes RFC & DIA, Its not many users but could this be a reason?

Please suggest at the earliest if possible how can I reduce this time and what can be the possible reasons for this High response time, my Integration Test is all held up cause of this 😊

Regards,

Nitin

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Feb 19, 2009 at 11:04 AM

    I suggest you to do a trace via ST01 in order to check where is the process been held...

    Regards

    Juan

    Add comment
    10|10000 characters needed characters exceeded