Unplanned Inspection Characteristics in Routing - Operation

[Former Member]

Hi experts,

What is the use of the function Unplanned Inspection Characteristics in Routing - Operation ? Its normally grayed off.

I am aware of the same in RR of the Inspection Lot.

Thanx

George

[former_member204463 · Accepted solution]

Hi Jommy,

The concept of Master Insp characteristics is that whenever there is a business scenario where you need to test the same charctaeristic over and over again, you can create a MIC and use it in any Task list/Insp Plan.

Whereas, in some cases, the insp char are used only for specific requirement and not used any where else, than you need to go for unplanned characteristic which you can add directly in the Task list screen or you can create the same in the RR screen.

I hope your question is answered.

Regards,

Keerthi.

[Former Member · Accepted solution]

Hi Keerthi,

Sorry my question was , why it is shown in Production order operations over view screen. And it is grayed off always.

Can we add unplanned Chars to production order once it is created with a routing with QC operation ?

Regds

Jomy

[Former Member · Accepted solution]

Hello Jomy,

Ok so you were asking the same for Production order. You wrote routing operation and my mind stuck there since I read it. I was searching for it. You make good exercised to me. LOL!!!

Anyways, in the production or process order the unplanned MIC does the same task of job what it used to de in QE51N or any other RR work sheet. And you can assign the Unplanned MIC to Pro. Order itself to the relevant operation. Let it be gray there, you just follow the steps to attach an unplanned MIC to Operation in the Order, and the same will be reflated to RR screen also.

- Select the operation line item.

- Now follow the path,,, Operation->Function for phase / for operation->Unplanned Inspection characteristics.

- Now it will lead you to the same screen for unplanned characteristic as you can have in other RR work lists.

Pls revert if there is any query.

Regards,

Shyamal

[Former Member · Accepted solution]

Hi Shyamal,

Very Helpful.

Thanks

Jomy