Skip to Content
avatar image
Former Member

How to update cost condition VPRS and Updation from VPRS to new cond ZVPR

Hi All,

How to do and is there any way to update the VPRS cost condition whenever vendor sends confirmation of material and cost after purchase order.

After receiving the confirmation form the vendor,the VPRS cost condition should get updated in the system automatically.

We have one cost condition type ZVPR which is same and consists of same properties of VPRS. How to update this ZVPR condition from VPRS Condition.

Thanks in advance....

Regards....Venkat

Edited by: venkat t on Feb 16, 2009 11:57 AM

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Feb 16, 2009 at 01:59 PM

    VPRS is calculated from material master cost. Are you going to change your material cost once you are receiving PO confirmation and cost from vendor, if so you can assign one requirement to VPRS, once your PO is confirmed, then determined VPRS cost and that time whatever price will be in your material master that will be copied to your pricing.

    To update ZVPR from VPRS, you can assign from step as VPRS cond type and can assign alt con base value to ZVPR cond type where you need to maintain KOMV-KBETR as 100000 i.e. 100%. ZVPR will just have same value as VPRS.

    Add comment
    10|10000 characters needed characters exceeded

  • Feb 17, 2009 at 06:25 PM

    Hi venkat

    Check the link

    [How to update cost condition VPRS and Updating from VPRS to new cond ZVPR;

    NOTE : Dont post in many forums

    Regards

    Srinath

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Srinath,

      In VPRS condition type,the refctype field is not appearing to assign ZVPR.

      regards..VM

  • avatar image
    Former Member
    Feb 17, 2009 at 06:33 PM

    Not resolved and it is in process

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Is there any control of field selection for the pricing condition type??

      Edited by: vm on Feb 17, 2009 9:15 PM