Hi all,
Would anyone be able to help me understand why the ordering of the output type in Output Determination Procedure is different than the Output Analysis ? The one provided below is the output analysis for a delivery document. Two questions posted here regarding this.
Q1: ZD04 output type is what i am after. In delivery doc, ZD04 output appear as green light. My question here is why is the ordering in analysis different than output procedure ?
Step 10 should be read first , then step 12, and so on.
Q2. Why did it display ZD04 not found in analysis when ZD04 appear on the delivery output as green light ? When i drill down, it show 2 access sequence. Access 10 stated Output found. Access 20 stated Output not found.
In Analysis Output: i have:
LDOO - Output not found
MAIL - manual output
PLOO - Output not found
Z940 - Output found
ZBOL - Output not found
ZD04 - OUTPUT NOT FOUND
The Output Determination Procedure as:
Step Counter CType
10 1 LD00
12 1 ZLFX
13 0 LALE
14 1 ZBOL
20 2 MAIL
75 1 ZD04
90 1 PL00
110 1 Z940
Thank you.
Joyce