Skip to Content
avatar image
Former Member

Not able to access tcode /virsa/vfat

Hi All,

We recently gave Firefighter access to some of our users.

The users are not able to access transaction "/virsa/vfat".They get the error"This function is not possible"

However if they add this tcode to their favorites,they are able to access it.

Can anyone help me figure out the reason for this strange issue.

Regards

Peeyush

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Feb 04, 2009 at 11:47 AM

    Hello Peeyush,

    Use "/n/virsa/vfat" transaction instead of "/virsa/vfat" for Firefighter access.

    Thanks and Regards,

    Jagat

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 04, 2009 at 12:02 PM

    Hello Peeyush,

    Just an explanation to Mr. Singh's answer - you can suffix "/n" with all your transactions for Virsa which you find in se93.

    Regards,

    Hersh.

    http://www.linkedin.com/in/hersh13

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 05, 2009 at 02:13 PM

    Thanks for your replies,but can anyone help me figure out the reason for this strange issue??

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Peeyesh

      All virsa transactions were created by virsa and it seems like SAP have not changed them much . So it may be working only on that way.

      If you check any SAP notes

      it will only specify to call firefighter using /n/VIRSA/VFAT

      . I dont think there is a note which tells the exact reason. Two things you can do :- either ask your abaper and debug why it is only working with /n . other one is to directly contact SAP support .

  • avatar image
    Former Member
    Feb 05, 2009 at 08:15 PM

    Hello Peeyush,

    Any tcode which have CUSTOMER NAMING convention attached works like that.

    Can you please give me any example where tcode name start with " / " and you are able to execute without /N

    Remember when you type tcode, they are COMMANDS for R/3. Command can start either with /N or /O or Z or Y if created by customer .

    Hope this answer your query.

    Regards,

    Surpreet

    Add comment
    10|10000 characters needed characters exceeded