Regardding Time Events confirmation.

[Former Member]

Hi PP Gurus,

Could anybody please pour light on Time Event confirmation configuration for Work center and Customization? Whenever I'm trying to do Time Event confirmation for Processing finish event getting following error:

Message no. RU407: Pair formation: Conflict with previous confirmation

Diagnosis

A time event with the record type B40 should be created. When checking whether this is permitted based on time events that already exist a time event with the record type R10 was found as the predecessor.

The record type B40 cannot be a successor to the record type R10.

If anybody came across the same please help.

Thanks & Regards,

Abu Arbab

[Former Member · Accepted solution]

Hi,

The sequence can be the exactly in the same way as you have mentioned.

For Set-up time:

First select the Set-up Start radio button.

Now if you have Set-up Interruption then select the " Interrrupt Setup" Button.

If you want to start the set-up again then select the " Set-up Start" again.It will auto-confirm the interruption finish when you use the radio button "Start setup".

Finally you have to select the radio-button " Set-up Finished" so that Set-up time is completed.

Now the same-way for Process Time.

"Please come back with proficient comments". Hope I'am proficient enough with the reply.

Best Regards.

[Former Member · Accepted solution]

Hi Aravind,

Thanks for 'proficient'ly resolving the issue. It's working now...

Thanks & Regards,

Abu Arbab

[Former Member]

Hi,

R10 stands for "Start setup" time for CIM confirmation and B40 stands for "Processing finish" time for confirmation.

This error message is telling you that you have not entered any value for the "Setup finish" time and also you have not even entered the start time for your Processing time.

Time events always work this way..

you have to start a particular time and then end it..then you can go for the next time.

Please try to select " Setup Finished" option and then go " Processing started" and then "Processing Finished".

Hope that helps. Award Points if helpful.

Best Regards.

[Former Member]

Hi Aravind,

Thanks for pompt reply.

See I've to capture following values using Time Event confirmation either through PDC system or manually.

Setup start

Setup inturruotion

Setup end

Processing start

Processing inturruption

Processing end

So, what will be the sequence of time events for making operation confirmation of an production order?

Please come back with proficient comments.

Thanks & Regards,

Abu Arbab