Skip to Content

Import Run after Test Run Fails in EMIGALL

Hi Gurus,

I am trying to check Obejct Status in Import Test Run. After that I run Import Actual Run. After an actual run I am not able to see the record through display Runtime Object /in Transaction level. But entry created in TEMKSV Table.

I am trying to open the created connection object in ES57. I am getting Address Number doesn't exit.

Could you please confirm if I made mistake while running Import Test Run.

Thank you,

Suneel.Uggina

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    Jun 12, 2018 at 09:58 PM

    Hi Suneel.Uggina,

    Too little information to understand what's the gap or the cause of the error that you describe.

    1. What does the Statistics information describe for the two runs - Test and the Actual run? Success or Error?

    2. Please check the SAP tables for the converted data. Does the connection object 1061068 match the Address number 277873 (from your screen shot) in the error line?

    3. Also check the Long Text of the error message. Maybe it will give you some additional information.

    Alternately, you try to create another test data record and try the Test Run by supplying the "test run" flag on the parameters tab on the Data Import screen? See attached screen shot.

    test-run-import-screen.jpg

    And then check TEMKSV- this test run should not create an entry in this table. Subsequently do your actual data import - without the Test Run flag enabled.

    Regards,

    Ashvinder


    Add comment
    10|10000 characters needed characters exceeded

  • Jun 13, 2018 at 08:31 AM

    Thanks Rana. I am able to resolve the issue with test run flag in Parameter level.

    Thank you

    Suneel.uggina

    Add comment
    10|10000 characters needed characters exceeded