Skip to Content
avatar image
Former Member

Error sending Email

Hi

thriugh scot when we are trying to send mail at the bottom of the screen its giving message

'Queue for incoming message is active' and all the mails get stuck in transit mode.

What could be problem and how to resolve this?

Thanks in advance.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Jan 22, 2009 at 10:47 AM

    Check that SAPCONNECT job is running fequently... Also go to SOST and check the stats of the outgoing messages. If theres any errors please post them here.

    regards

    Juan

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Dear SDN member,

      I am getting same error in while sending messages fron SBWP :Message cannot be transferred to node SMTP due to connection error (final)

      1. SAP&CONNECTALL is scheduled/released every 10 min

      2. SCOT is configured.

      3. SAPCONNECT is active in SICF

      4. Our SAP version ECC 6.0

      Thanks very much in advance

      sushma

  • avatar image
    Former Member
    Jan 23, 2009 at 09:50 AM

    Hi Vithal,

    Kindly check the mail sending access is provided for your servers on realy servers.

    Regards,

    Rahul.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi All,

      I am getting same error in while sending messages fron SBWP :Message cannot be transferred to node SMTP due to connection error (final)

      SCOT is configured.

      SAPCONNECT is active in SICF

      Our SAP version SAP R3 4.7 x200

      Thanks & regards,

      Saket

      Error Log:

      Definately cannot transfer message to node SMTP due to connection error

          Message no. XS816

      Diagnosis

          Due to a technical fault, the system could not set up a connection to

          the RFC destination Check port and mail server for SMTP nodes.

          Therefore, the message could not be transferred to node SMTP.

      System Response

          The system was unable to transfer the message.

          Additional information of the node used (in the system language of the

          node):

      Procedure

      Check the connection from R/3 to node SMTP. Perhaps the node is not

      assigned to the correct RFC destination. If so, correct this in

      Customizing.

      Otherwise use RFC destination management to check the RFC connection to

      destination Check port and mail server for SMTP nodes.

      If R/3 is in productive operation, it is advisable to reroute

      provisionally to another node.

      You should therefore notify your system administrator.