Skip to Content
avatar image
Former Member

Two Networks

Hi All,

In what circumstances two networks get generated instead of one? Any inputs?

Bele

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Jan 21, 2009 at 08:15 AM

    It based on requirement , convience & in which way you have to see your costing related reports.

    Normally tow netwrok is used when there are large no of activity being used, to make clear understanding of scheduling.

    Regards

    Nitin

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jan 21, 2009 at 08:24 AM

    It actually depends on the requirement. If you are executing a simple project, then only one n/w might fulfill your needs. If a complex project/ Turn key project with lots of activities is being executed, then you may use more than one networks. Ideally one network under each WBS. It would you in scheduling, as well as reporting.

    Amaresh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      hi,

      go to project profile (opsa), then in planning board/date tab below network profile there is one field for network asst, select 1( for project defination).

      then one network ll b created 4 each project

      ashis

  • avatar image
    Former Member
    Feb 02, 2009 at 01:44 PM

    ok

    Add comment
    10|10000 characters needed characters exceeded