on 01-19-2009 6:45 PM
Hi,
We need to replace our quality server with a new one.While configuring TMS,with the new replacement of our quality server,we are facing an error.
Our development server is the domain controller and we have added our new QA and then deleted the old system and previous TMS configuration.But after deleting the configuration in our Production also,we get an error while adding it in the landscape.
Password should contain atleast 2 numericals(0-9) for TMSADM.We changed and tried but of no use.
Our password is welcome@01 which goes as per the password exception table.
Can anyone help us in resolving this issue.Do we need to change the parameters and restart the system?Or is there any resolution like unlocking any table etc.
Please help.Early response would be of great help as our landscape is affected.
Regards,
Sudheer.
Hi Sudheer,
Make sure the client id open
in client other than 000 open table TMSCROUTE using SE11 and create following entry.
sysname = ,ADMPWD
Routestring=USER
save the entry then try to configure STMS in 000.
Try to add the Entry in All 3 Systems.
Also Refer Note 1568362 - TMSADM password change
Regards,
Vaibhav
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sudheer,
We also got the same error message which you have posted. Incase if you have got the resolution for the problem please help us in sharing the issue.
Regards,
Avinash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sudheer,
We also got the same error message which you have posted. Incase if you have got the resolution for the problem please help us in sharing the issue.
Regards,
Avinash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sudheer Koppireddy,
can you try with the help below :
http://help.sap.com/saphelp_nw70/helpdata/en/44/b4a0c17acc11d1899e0000e829fbbd/frameset.htm
did you also try STMS > system overview >Extras >Reset User TMSADM ?
Regards,
S.Manu.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.