RCVR_DETERMINATION.NO_RECEIVER_CASE_BE

[Former Member]

Hi,

Im trying the following scenario

synchronous http to rfc scenario.

Im sending the http via a httpclient and its giving me the

RCVR_DETERMINATION.NO_RECEIVER_CASE_BE error.

I've checked my ID and all the objects have been activated.

I've checked and refresh SXI_CACHE.

Is there anything else i can check to see where have i gone wrong?

Thanks.

[VijayKonam · Accepted solution]

For the sender service, sender interface and namespace combination, check if you have created a receiver determination with a receiver service/system in ID. The sender set of details must be same.

You should give the same set of details in the http tool too while testing.

VJ

[AaronLong]

Log on your Integration Directory, go to 'Test Configuration Scenario' to run the scenario step by step. you should be able to figure out the problem.

[former_member208856]

You have one RFC Receiver communication channel, it should be created under a system not a service.

Sandeep

[dharamveer_gaur2]

Hi

Check is there any object is not Activated.

Perform full Cache Refresh as suggested by Sudhir.

[Former Member]

Hi,

thanks for all the help. I've tried the CPA full refresh but im still getting the same error

[Former Member]

Hi Yu

for the error RCVR_DETERMINATION.NO_RECEIVER_CASE_BE error

look at these thrad discussed the same

Regards

Abhishek

[SudhirT]

Try after performing full cache refresh http://<saphost>:<port>/CPACache/refresh?mode=full with user PIDIRUSER.

Thanks!

[Former Member]

Hi Yu

Check this solved thread for the same issue:

[]

Regards

Praveen

[samiullah_qureshi]

Hi,

Check whether you are giving the same service name, interface and namespace in the http client as you have maintained in Receiver Determination.

Regards,

Sami.