Error in IDOC ststus , for interface IDOC to File

[Former Member]

Hi All,

iI am doing IDOC to file interface , in which i am using IDOC Orders05, we are using the same IDOC for other interface to connect with DOTNET connectors , when i trigger the IDOC ORDERS05 for my interface when i check the ststus , in which it is pointing the to partner No and Port to that dontnet, not to my Iterface for SAP XI , anyone there to help me in this isssue

Thanking you

Sridhar

[VijayKonam · Accepted solution]

You need to change the we21 port configuration by adding your idoc as outbound. Did you configure the Idoc for dot net connector on ecc? If so you might have to change the entire ecenario into XI based and receiver determination based on content of the idoc.

VJ

[Former Member · Accepted solution]

thank you very much ,

i have added in the partner profile in transacation WE20, but , i dont know where to added in port ,i hope there we will giving only RFC destination , we will not be giving any IDOC for that port, correct be if iam wrong

Thanking you

Sridhar

[Former Member · Accepted solution]

Hello,

While sending Idoc you will be providing the Port which in turn needs RFC Destination and this is one which takes the document to External system configured in RFC.

If you need to send the idoc to External Systems other than R/3 then you need to use T type connection which uses JCO for estblishing session. if it is R/3 then requires logon credentails and type 3 for configuring RFC.

HTH

Rajesh

[Former Member · Accepted solution]

thank you very much,

we are already using for external system with connection Type T, for IDOC ORDERS05, now , the isssue i have having is that i have done one new interface for IDOC to File using the same IDOC , and the isssue is that when i trigger the IDOC , the IDOC is pointing that that RFC of Type T not to my Interface RFC destination of Type 3

i dont know how to chage it

please healp me in this

[former_member208856 · Accepted solution]

In Partner Profile in WE20, you have two entry of this idoc as Outbound.

1. in Type 3 Port

2. in Type T Port.

Delete one, which you do not want.

Sandeep

[Former Member · Accepted solution]

yes we have two partner profile for External system and one for SAP XI , in bothe we have given IDOC orders05 , i do have a question we cannot use same IDOCS for two such different interface

please correct me if i am wrong

i have changed also , but when i test in IDOC Tool iprocess manualy,

it is pointing to the same RFC destination for the External system

[SudhirT]

Have a look at this guide for idoc configuration

https://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/e07dcaa0-a92b-2a10-3a96-b3d942bd...

Thanks!