Skip to Content
0
Jun 04, 2018 at 01:50 PM

Routing Migration via LTMC

1071 Views

Dear Experts,

Can You please help on the following problem:

I’m getting an error, when importing a Routing that is basically a loop.

I’m not able to import a Routing without a Sequence (which should be possible since it isn't a mandatory sheet).

In order to proceed, I created a sequence and defined the Sequence Category as Standard Sequence, therefore leaving Reference Sequence “Blank”.
When validating data I get an error message advising “Reference Sequence does not exist”, therefore I introduced Reference Sequence “0”.

As a result, when validating again, I get the error message “A standard sequence cannot have a reference sequence”.

I’ve searched for the above errors but wasn’t enable to find a solution.

I hope you can help me solve this issue.

Thank You in advance for your attention.
Best Regards.