Skip to Content
avatar image
Former Member

How to set table control size?

Hello Experts,

I hv created a maintenance view and after generated table maintenance view for it.

now it adjusts the size of table control in table maintenance generation.

I want to change the size (width) of table control and again re-generate the table maintenance.

But when re-generation occurs, table control size is set to initial.

why it is happening? and wt to do to solve this issue?

Regards,

R.Hanks

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jan 07, 2009 at 02:29 PM

    Hi Ronny,

    Everytime that you regenerate a table maintenance view, the automatic generated dynpro is regenerated also. That's why you must adjust the dynpro containing the table control to your needs every time you regenerate the maintenance view.

    You can do this by entering to the maintenance view, following by this:

    1. System -> Status

    2. Get the Program Name and the No. of Dynpro

    3. Go to transaction SE51

    4. Enter the Program name and No. of Dynpro obtained and check Element List

    5. Click on Change

    6. Adjust the Fields to the width you want to, and save.

    Hope it helps.

    Regards,

    Gilberto Li

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Apr 24, 2009 at 10:16 AM

    thks

    Add comment
    10|10000 characters needed characters exceeded