on 12-29-2008 11:13 AM
Dear SAPians,
I am facing a problem regarding Manual valuation window during Result recording. I am maintaining the inspection plan & maintaining sampling procedure with Fixed sample etc. and it is working fine to 99% of inspection lot. When i create a new inspection plan. it suddenly not making Automatic Valuation, What may be the reason??? please tell me...
Regards.
Edited by: ATUL MITTAL on Dec 29, 2008 12:16 PM
Hello Atul,
Please check the valuation mode assigend to the sampling procedure for the characteristic in the inspection plan(Task List).
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hey Atul,
If you want to make it Manual then keep the "Valuation mode" in the sampling procedure as "Manual Valuation", else you should set it according to the requirement.
e.g. If you set......
Sampling type: fixed sample
Valuation mode: attributive inspection according to nonconforming units
As a result, a sampling instruction with the parameters sample size 'n' and acceptance number 'c' is stored in the sampling procedure.The sampling instruction is independent of the lot size (unless the lot size is smaller than the fixed sample size).
Regards,
Shyamal
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.