Unable to change parameter order in CR 9

[Former Member]

Hello,

I created a report with six parameters. Two of the parameters (@fromDate and @thruDate) were created by CR automatically to link to the stored procedure.

I'd like @fromDate and @thruDate to be the first parameters listed in the prompt. I tried "moving the parameters up" in the field explorer window, but the order reverts after I save and close the report. Has anyone had that problem before?

Teddy

Edited by: teddy sincire on Dec 23, 2008 12:24 AM

Edited by: teddy sincire on Dec 23, 2008 12:25 AM

[Former Member · Accepted solution]

Please refer following SAP notes:

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/oss_notes_boj/sdn_oss_boj_...

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/oss_notes_boj/sdn_oss_boj_...

Also, you may install the highest level of service pack for Crystal Reports 9 and then check for the results.Following is the link:

http://resources.businessobjects.com/support/additional_downloads/service_packs/crystal_reports_en.a...

[Former Member · Accepted solution]

Thanks for the quick (and accurate) answer Prathamesh!

I installed both service packs and the report was fixed.

Thanks again!

Teddy