Upgrade to target release ECC EHP 3 Stack 3

[mubarakshabna_asmi]

All:

Has any one tried a direct upgrade from R/3 4.7 EXT 2 to ECC 6.0 EHP 3 Stack 3.

I am getting too many conflicts during the EHP_INCLUSION.

Thanks

S.

[markus_doehr2 · Accepted solution]

Did you generate the full necessary stack through Maintenance Optimizer? SolMan will generate everything you need based on the source system.

Markus

[mubarakshabna_asmi · Accepted solution]

Markus,

I got the list from MOpz for EHP3 Stack 3. It had included a component ESS-SE 603, but in the EHP_INCLUSION phase I get the following error:

SEVERE ERROR: Internal error (no compinfo for ECC-SE).

(Function: R3upAddonTableInitialize)

I then created another stack configuration file and did not select this component. Also I removed the entry from /usr/sap/put/bin/NAVERSCURR.DMP which looked like below:

_________________________________________________________________________________

CURRENT ECC-SE 501 +W

CURRENT SAP_HRCAR 470 2008121309571920081213095719+WSAPKBBJ021 SAPKBBJ021 Sub component S

_______________________________________________________________________________

This helped. You'll notice the ECC-SE 501 line looks different than the next one.

Thanks

Markus

[markus_doehr2 · Accepted solution]

I see.

So your problem is solved?

Markus

[mubarakshabna_asmi · Accepted solution]

Yes Markus for now. The problem is solved. I am not sure if that was the right thing to do, but this is a test upgrade. Thanks for the reply though.

Thanks

Shabna