Skip to Content
author's profile photo Former Member
Former Member

Infocube data

Hallo,

between R/3 and BW system data difference? I have one field "type sum" in bw which are 3times bigger than in R/3 system, for example if in R/3 is 1000 in BW will be 3000.

Thanks for attentions and your answers.

Best regards,

Petras Rymkevicius

Add a comment
10|10000 characters needed characters exceeded

Related questions

3 Answers

  • Best Answer
    author's profile photo Former Member
    Former Member
    Posted on Dec 22, 2008 at 11:27 AM

    Hi All,

    There might be three posibilities:

    1. Abap Code that is written to update the field type sum.

    2.Chances of not getting the previous request deleted has not happend.

    3.Mapping problem

    eg:In the update rule you might have defined it has Contant C and in case of transfer rule you might have defined it has constant M .there might be a chance that it is getting Summed UP.

    I hope this might Help.

    Regards

    Kiran.Nagarajappa

    Add a comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hallo all,

      Is 2 system BW development and BW test. I transport corectly I think. In development system is everything alright, in Test "no" with one virtual key figure(I said it in question).. WIth ABAP is everything alright, transfer rules also, this Virtual key figure didn't have any formulas. I everything look in test system and I compare with BW development system.. One difference in additional properties of Content release between this system is 3.5/03 in BW development and in BW test 3.5/01 but i think it's not important.

      Best regards,

      Petras R.

  • Posted on Dec 19, 2008 at 02:35 PM

    Hi Petras,

    Cehck your transfer rules and Update rules, whether you have made any wrong mappings ...

    Also check data in your PSA, hw it is apeparing in your PSA

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Dec 21, 2008 at 08:03 AM

    Hi Petras......

    Which type of target u r using.........is it a DSO..............was it empty...........or alreadt it had some data.....look if u already hav some data there.......then check the update mode .....whetehr it is overwritten or Summation.........if Summation then....

    Suppose...........

    Product...............Amount

    A..........................2000

    Now again a new entry .......

    Product...............Amount

    A..........................1000

    Then now if u check the content of the DSO.........it will be........

    Product...............Amount

    A..........................3000

    So this may be one of the reason.............otherwise u hav to check the routines whatever u hav used there.........

    Regards,

    Debjani.......

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.