cancel
Showing results for 
Search instead for 
Did you mean: 

No Output for selection exist in T.Code VL70

Former Member
0 Kudos

Hi

I would like to take Print out of Picking. Output type i have choosen as EK00. after entering the required delivery no. system in saying No Output for Selection exist.

where i have to do configuration. if i am not wrong Output type application is "V4".

my requirement is want to take the printout for outboudn deliveries for picking.

request you to guide.

Accepted Solutions (1)

Accepted Solutions (1)

former_member204513
Active Contributor
0 Kudos

Dear Jagadish,

Check all these settings,

1.Check have you assigned your Output type EK00 to the shipping point(Enterprise Structure - Definition of Shipping point), also maintain the time and medium.

2. Use TCode V/38, check ahve you maintained the condition type EK00, maintained the time,print parameters and transmission medium.

Also check assigned the processing routines Prog: RVADEK1,Form Routine: ENTRY, Form:SD_PICK_SINGLE

3. Have you maintained the print parameters based on the shipping point.

through transaction VP01SHP

If you have maintined the pick list condition EK00 in the shipping point with all the details, then go to VP01SHP --> Select Shipping (Spec case) V4 --> Select Picking List EK00 --> now you can maintain the entries for your Shipping point and output Device ..etc.

I hope this will help you,

Regards,

Murali.

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi Jagadish,

Application should be V2, picking list = EK00 and output type = LD00

check this and let me know

thanks

Mohan