Unable to create multiple transport target groups in SLD

[Former Member]

We have multiple R/3 QA systems but just 1 XI QA system and we need to test interfaces with all R/3 QA client at the same time. My XI development team has asked to explore whether its possible to create multiple target systems.

Currenlty R3_dev has R3_QA1 as target business system, we would like to add R3_QA2 as target system for R3_dev.

There is a "add/change" option in Transport tab and there is a grid which seems to imply that multilple entries are possible.

I have added R3_QA2 to the Group "Qa_Bus_Group" and was able to replace

R3_QA1 with R3_QA2 however I was unable to create multiple target systems.

I was wondering if anyone ran into this issue and any suggestions are welcome. Thanks in advance.

[Former Member]

Hi Syed,

You can create multiple target systems only for different business system groups.If all the business systems like R3_QA1,R3_QA2, R3_QA3 belong to the same business group "QA_BUS_GROUP" , then you can have only one among the three system as target.

So R3_DEV can have only one system as target either R3_QA1 Or R3_QA2 or R3_QA3 since they belong to the same business group "QA_BUS_GROUP".

If there are three different business system groups then you can have 3 target systems that correspond to their respective business system groups ,in this case source business system can be assigned to the 3 target systems that belong to different business system groups .

Since that is not the case with your scenario, you cannot create multiple target systems.

Regards,

Laawanya

[Former Member]

All,

We have the same issue where we have one PI and multiple ECC QA clients connect on.

Source system also changes with each QA client. e.g N legacy to one PI to N ECC ( All for QA testing)

I am surprised that we can create one Target business system per Group. This is big bottleneck for PI considering it says it support many to Many. Is there a solutions for this in PI 7.1.6.

The other option i am thinking is to import one QA and create scenarios manually in ID for others but that would mean touching the QA system.

Thanks & Please advice.

[Former Member]

H Syed

This should not be and issue.

Check with your admin. You can add all Q systems as target to the same group itself.

Thanks

Gaurav