Skip to Content
author's profile photo Former Member
Former Member

J1IS for Partial Return of Exciseble goods

Dear all,

I have created a PO 100 Qty

Done GR 100 Qty

20 were found bad hence return delivered through 122

Posted Excise Invoice for Redceived qty 100.

WRT 122 material doc i have created an outgoing excise Invoice In J1IS.

In J1iv when I do Release to accounting i get below error

Error in allocating Excise invoice number Interva

not found Number object J_1IEXCLOC

I have checked the number range for it for the series group and it exists.

Other issue in the same context is i am not able to take the printout of the same in J1IV even after message determination settings for JEXC Transaction.

Thanks and Regards


Add a comment
10|10000 characters needed characters exceeded

Related questions

1 Answer

  • Best Answer
    author's profile photo Former Member
    Former Member
    Posted on Dec 18, 2008 at 06:02 AM


    Please check the number range status of the object J_1IEXCLOC for respective series group and check in the header table by going to SE16 what is the status for the same. If it is more than what you see in the SNRO transaction then kindly reset to correct number and create the J1IS document.



    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.