on 12-18-2008 4:21 AM
Hi All,
I am trying to create a new Unit of Measurement PCS. The system is giving the folloiwing warning:
ISO code PCE is already used for measurement unit ST
Message no. BM060
Diagnosis
You have maintained the same ISO code for two different measurement units with the same dimension.
System Response
You can assign the same ISO code to two different measurement units with the same dimension,
However, this can lead to EDI problems later. EDI uses the ISO codes as a measurement unit key. If the same ISO code is maintained for several measurement units, a different measurement unit can be assigned to the ISO code measurement unit in the target system as in the source system.
In addition, a unique assignment of the ISO code to a measurement unit is a prerequisite for implementing the mobile DSD solution.
Procedure
Try to keep measurement unit <-> ISO code assignments unique.
Should I go ahead & save the new Unit or something needs to be done somewhere?
Pls. advice.
Regards,
Hi
If u r not going to use EDI or Mobile DSD solution then there is no problem u can go ahead.
orelse change the ISO code of your own unit and then save it. If u try to create a unit by copying another unit then ISO code will be defaulted and hence we need to change the ISO code of our unit.
Reg
Raja
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
No need to worry.U can go ahead with the warning message.
regards,
indranil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
ISO codes
maintain new ISO codes with the function New entries.
and then make new assigmnent of unit of measurement to ISO code (in order to make it unique)
and proceed further.
Sunny
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
103 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.