Skip to Content

Setting QRFC Queue Status to STOP

Hello

We will be scheduling reports in Prod to auto restart stopped outbound and inbound QRFC queues. But before implementing these changes we need to know if these reports are working fine TEST environemnt. Can anyone recommend us a way of setting the Status of QRFC queues to STOP.

Thanks.

Kiran

Add a comment
10|10000 characters needed characters exceeded

Assigned Tags

Related questions

4 Answers

  • Best Answer
    Posted on Dec 17, 2008 at 07:00 PM

    Hi Kiran,

    your purpose is to make some error entries in test system so that when the report runs these are automatically cleared. for this if you have R3 system then just change some port in XI/R3 and try to post a idoc. after the entry is made with error in LUW. you can correct the port and see if the entry is removed when report is scheduled.

    thanks.

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Dec 17, 2008 at 05:05 PM

    Hello,

    In Transaction SMQR, deregister the queues.

    Regards,

    Sreenivas

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Dec 18, 2008 at 12:56 AM

    Hi Kiran

    Along with suggested above.

    You can set up a dummy scenario or use existing irrespective of adapter type where you send data to PI and receiver config is not correct. Then all messages will be stuck. change the config and correct it. This should allow all the queues to work fine. as required.

    Thanks

    Gaurav

    Add a comment
    10|10000 characters needed characters exceeded

    • Thanks everyone !!

      We executed a simple scenario where we selected the Sender SOAP of the type EOIO which enabled us to define a specific queue e.g. TEST_QUEUE. In the Receiver SOAP we entered incorrect usrr id which caused the messages to be blocked in the queues. Once that was done we again reset the password to the correct values and ran our reports to restart QRFC inbound queues which helped us verify the auto restart of queues.

      Best Regards,

      Kiran

  • author's profile photo Former Member
    Former Member
    Posted on Dec 18, 2008 at 07:07 AM

    Hi Kiran

    follow this thread

    adapter-engine-queues

    regards

    sandeep

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.