Skip to Content
avatar image
Former Member

Why using Output types WMTA is not create TO Auto in some order type?

Hi All

I would like to know why I create D/O by using order type(ZKBN) that have already created output types WMTA but the system do not create TO Auto. As I create the new D/O by using order type(ZTAN) why the system create TO Auto which I have already all configured in SPRO.(Maintain & Assign Output type and Output Determination Procedures and then configure at Interfaces-->define movement type)

Please help and explian me.

Thanks you....

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 18, 2008 at 03:36 PM

    Chalermpol,

    Is output type WMTA at least being proposed (created) but no TO printed? Or is WMTA not proposed at all. You can find this by looking at the Delivery, Extras > Output > Header or Item - wherever you have it configured to be.

    Just a few places to look - most of which you probably already know:

    Also keep in mind that the IM movement type you are using may or may not be the same movement type in WM (example, IM mvmt types 102 GR reversal & 122 GR return to vendor can both use WM movement type 102)

    Compare the settings for movement types under SPRO: Logistics Execution > Warehouse Management > Activities > Transfers > Define Movement Types

    Compare IM to WM Interface for both movement types: SPRO: Logistics Execution > Warehouse Management >Interfaces > Inventory Management > Define Movement Types > LE-WM Interface to Inventory Management

    Have you checked the warehouse print parameters for each movement type? - assuming that ZTAN (standard item) & ZKBN (consignment fill up) use different movement types (SPRO: Logistics Execution > Warehouse Management > Activities > Activities) if these are net set right, then the Transfer Order will not generate.

    Hope this helps

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 17, 2008 at 09:14 PM

    Chalermpol,

    Please check the following:

    1. In Item category ZKBN - make sure the "Relevant for picking" box is checked (SPRO path: Logistics Execution > Shipping > Deliveries > Define Item Categories for Deliveries)

    This is set in the delivered KBN which I assume you copied.

    2. Make sure the same output Determination procedure is assigned to both item categories (SPRO path: Logistics Execution > Shipping > Basic Shipping Functions > Output Control > Output Determination > Maintain Output Determination for Outbound Deliveries > Assign Output Determination Procedures)

    Chances are, the second option above will fix the problem - assuming the IM>WM interface movement types are correct as you indicated.

    I hope this helps

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi John

      Thanks you for youradvice in my question

      As per you advice me about order type(ZKBN) which I copied ZKBN from ZTAN so I thaink that the system should create TO automatic same ZTAN and not only I have already configure both in your path (SPRO path: Logistics Execution > Shipping > Basic Shipping Functions > Output Control > Output Determination > Maintain Output Determination for Outbound Deliveries > Assign Output Determination Procedures) but system not yet create TO Auto in order types ZKBN.

      I sure that I configure all path in output & interface IM>WM.

      Please help me agian if you know.

      thanks you.