Skip to Content
avatar image
Former Member

Picking Quantity

I use vl02n to input the picking quantity, but I don't know why no matter i input picking quantity is 2, 20 or 30, the picking quantity will be full pick after save. I don't know what's wrong. Thanks!

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Dec 16, 2008 at 04:31 AM

    Hi Portfolio,

    check the item category configuration for delivery. in that there is settings for pick, you might have selected auto pick or not relevant for picking, in which case the pick quantity is not cheked and upon save is showing as directly picked

    to correct the issue, you can change the settings to show as check the quantity and then do the pick in whcih case it will check for pick quanityt

    Thanks

    Akasha

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 16, 2008 at 04:33 AM

    Hi,

    This is because the material you are using is either in the form of rolls or skids so they cannot be taken as half or any other quantity. It will be taken as a whole. E.g. If it is a roll of paper you cannot cut the roll into smaller rolls. They have a standard size and so it will be picked by the system completely. Please check the setting of the material in material master and the Unit of measure.

    Regards,

    Shanu.

    Add comment
    10|10000 characters needed characters exceeded