Skip to Content
avatar image
Former Member

Display popup message on SRM portal

Hi,

I need to display a popup message on the SRM portal while doing a PO confirmation. Can you please guide me how to do it?

Do I need to modify the templates or can it be done using a BADI?

Thanks in advance.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 10, 2008 at 01:27 PM

    Hi Anu,

    I dont think that you can display a pop-up message in the web. But for issuing an error message in PO confirmation you can use the BBP_DOC_CHECK_BADI.

    Thanks,

    Pradeep

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Disha,

      Thanks for your reply.

      I have gone through the threads and the sample code also. But i still don't understand how to display a pop up using those two BADIs.

      Can u please help?

      Thanks.

  • avatar image
    Former Member
    Dec 11, 2008 at 09:29 AM

    Hi Anu,

    The BBP_DOC_CHECK BADI will definitely work. Please make sure you have completed the logic as below:

    IF FLT_VAL = 'BUS2203' AND ( IV_MODE = 'T' OR IV_MODE = 'U' ).
    
    * Populate your message into this table ET_MESSAGES
    
    ENDIF.

    Regards

    Kathirvel

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Anu,

      Unfortunately that would be very much complex and also involve standard template changes to add the script.

      I would suggest to go with the error messages, as it is a very much advisable alternative.

      Hope this clarifies.

      Regards

      Kathirvel