Skip to Content
avatar image
Former Member

LT01 manual processing

i have to clear the stock in 921 and 922 storage type.(there is no inventory) but the total number of items are more than 1000 and many of them are special stocks (against WBS number). I use LT01 to create TO and check each item in LS24 for Storage Type. This is taking too much of my time, is there any other procedure to avoid such manual TO creations?

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    May 23, 2018 at 02:52 PM

    There is no tool that can clean up a mess considering the different reasons for the mess and taking the right decision based on the found condition.

    Unfortunately is your given information just rough and by far not enough to get an idea what the problem is and how you actually solve it with LT01 (can't even imagine that this would be the right solution)

    For mass processing you always have the well known tools like batch input and LSMW, but if you are not familiar with it, then it will not really speed up the process, you just spend your time on developing the tool and testing it while the execution finally is just a few minutes, never forget or underestimate this development and testing process.

    Why is such manual TO process at all needed, what went wrong, what is missed in your customizing, what is the process in general?

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 23, 2018 at 06:42 PM

    Dear Jurgen

    I am thankful for your support, your reply opened up my way forward.

    Will buzz you after a while.


    Mustafa Ahmed

    Add comment
    10|10000 characters needed characters exceeded