Hi all,
I am having the following problem:
I am loading data from one DSO to another one (using Full extraction from Active table). The target DSO has no data.
In the transformation I am using an End Routine to assign a number of key figures.
After I run the DTP, I check the New Data in the target DSO and all is well. However, after I activate the data in the target DSO, all the key figures have been reset to 0 when I perform Display Data.
When I load the exact same DSO using a 'normal' transformation (no End Routine, but routines for the individual rules), then the problem does not occur and Display Data shows the correct data.
What am I missing here?