Flexible specification for Inspection point

[former_member284946]

Hello,

I need to use a flexible specification for MIC in inspection point , now I use exit : QAPP_CUST_IP_F4 for changes MIC specification. But when I checked the old inspection point (same inspection lot), the lastest specification was overwrite to the past inspection point in same MIC

[busyaban7]

Hi Wanchaloem,

If you don't wish the old results to be over-written, then may be you can try using the exit "QEEM0007 User exit: add. functions after completing partial sample" too, after the result recording for new inspection point. You can code the logic like - before execution, it should capture all the historic results recorded for the same inspection point, so that after result recording of any latest record, the previous values needs to be reset back using this mentioned User Exit.

Thanks,

Arijit