cancel
Showing results for 
Search instead for 
Did you mean: 

Calcel lot

Former Member
0 Kudos

Hi,

The lot is in created state, i want to cancel the lot without cancelling the document.

in qa02 when i tried to cancell the cancel field is in gray mode. If the lot is in released state this field is in active mode.

thanks and regards,

Srinivas

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

Hello Srinivas,

Please check this thread.

Best Regards,

Tiago Magalhães

Former Member
0 Kudos

Hi,

Thanks for the reply,

These lots are old lots whch were created in 2005, is there any way out to changes the status of the lot to cancel without cancelling the document.

Regards,

Srinivas

Former Member
0 Kudos

Hi Gurus,

The lot is in created state, and you want to cancel the lot without cancelling the document. Follow the below steps.

1. Go to QP01 transaction, enter material code & plant and press enter key, give type 5 against usage & 4 against status and save the transaction.

2. Go to QA32, select the Inspection lot item which you are looking and click on "Inspection lot" tab, click on "Insp.Specifications" tab, give the key date as current date and click on "Task list/spec" tab. You can see the message "Inspection plan ...... was assigned to the inspection lot". Then save the transaction.

3. Give the UD to the inspection lot then go to QA12 (Change Inspection Lot) --> Enter Inspection lot to cancel --> Go to Menu bar " Usage Decision" --> Functions --> Cancel Lot then SAVE it . Your Inspection lot will be cancelled.

Regards,

Krishna Reddy

Former Member
0 Kudos

Hi,

Krishna,

If the lot is in released , we can directly cancel the lot from qa02-inspection lot-functions-cancel.

we need not go for UD also.

Thanks and Regards,

Srinivas

Former Member
0 Kudos

Hi sap erp,

If your objective is only to cancel the inspection lot then you give the UD to the inspection lot then --> QA12 (Change Inspection Lot) --> Enter Inspection lot to cancel --> Go to Menu bar " Usage Decision" --> Functions --> Cancel Lot then SAVE it . Your Inspection lot will be cancelled.

Thanks!

preethi

Former Member
0 Kudos

Hi, preethi.

thanks for the repqly, if i want i can do it by releasing the lot, if the lot is released state i can cancel the same from QA02.

But i want to do it from created state,

thanks,

srinivas