Skip to Content

CM02 shows the same available capacity

Dear all,

I am wondering why the available capacity for a work center remains the same in CM02 even after reducing the operating time.

Operating time = (Working time - Break time) x Capacity utilization rate/100%

https://archive.sap.com/discussions/thread/3263305

I have reduced to 2 H of operating time per day for my test, but no change in CM02 as a total available capacity.

Do I have to reinitialize the capacity of the work center?

Thanks in advance

teypb.png (27.9 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • May 22 at 04:53 PM

    Hello

    Are you sure you made the changes in the Capacity Active Version? On your work center you can define several versions of capacity but only the one you refer in the capacity header will be active.

    Therefore, you should ensure that you set a value for the field Active Version in the capacity header profile. You can compare with the capacity profile shown in the link below:

    https://wiki.scn.sap.com/wiki/display/ERPMan/CRP%3A+Basic+Work+Center+Settings+for+Capacity+Planning

    Regards,
    Caetano

    Add comment
    10|10000 characters needed characters exceeded