delete data

[p_m8]

I have loaded some data into the InfoObject master data already.

I then activated the Time Dependent indicator for some of its attributes. Activated the InfoObject again.

Then I uncheck the Time Dependent indicator of this attributes, and activated the InfoObject again.

When I try to delete the data that have been loaded into this InfoObject master data, I hit the following:

Status of InfoObject ZPUR_ITM is inconsistent

Message no. RSDMD130

Diagnosis

InfoObject ZPUR_ITM is in an inconsistent state. It is possible that it is not active.

Procedure

Activate the InfoObject and try the action again.

I have tried to activate the InfoObject, but still failed.

How can I delete this data now? Please advice.

[former_member205352 · Accepted solution]

Try checking the consistency and repair in RSRV transaction.

or

Use SE14 for deleting and reorg.

Hope this helps.

[Former Member]

Hi,

You will have to delete the data from all the table in SE14 .i.e. P,Q and X,Y also if some time dependents were navigational object...to make it consistent...once deleted then only you will be able to activate it.

Thanks

Ajeet