cancel
Showing results for 
Search instead for 
Did you mean: 

Recording calibration results

Former Member
0 Kudos

Experts,

I have made cal order and lot no. is also created. There are four target values (Eqpt range vaues ex. 5LPM,10 LPM, 15 LPM, 20 LPM) defined as various activities (Char line nos.10, 20, 30, 40)in the task list of that eqpt. Also,3 sets of measured records for one target value are required.Now when I start recordiing the result, it is only allowing to record against one Characteristics line item i.e. activity 10. It is not going to the next char automatically eventhough the setting is done for that.

Can any body tell me how to complete the result recording for all Insp. Char?

Thanks in advance.

Manu

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Dear

This can happen only if "task list" is changed after rescheduling.

Try below steps

1. Cancel assignment through IP42 first.

2. Assign the correct group of task list through IP42.

3. Reschedule it though IP10 for further inspection lot.

4 Call manual lot.

5 Try to enter the result.

AYK

Former Member
0 Kudos

Hi,

There is setting for Recording configuration in the Quality Inspection > Results Recording menu. This Recording configuration is assigned at the plant level in the Basic Settings of the QM. Please check the assignment of Recording configuration in the Results recording tab. Its better to assign Automatic Close (in Recording configuration) so that system will automatically ask for valuation of the characteristics.

Regards, Manoj

Former Member
0 Kudos

hi

there is no automation getting next operation.

go through teh T-code QE51n or QA32

-ashok

former_member187991
Active Contributor
0 Kudos

hi

i think you are usign QE17 which is used for result recording for particular operation with MIC ,try to use QE51N , in the select screen specify the inspection type 14 and execute.

here also you have to save each opeartion with values manually ,once you save operation 10 it will lead to next operation

regards

thyagarajan

Former Member
0 Kudos

I am facing same problem in QE51N & QA32 ......

Kindly tell me other char attributes settings reqd ...

Manu