increasing the Maximum Number of Dimension Filter values to more than 100?

[Former Member]

Hi,

we're trying to increase the Help Values inside the Dimension Filter to more than 100 but it's not working as expected, the values are shown fine but they can't be selected properly with a check mark and all, the below image shows the issue, when clicking select all and the filter contains more than 100 values the rest (8) values aren't shown as selected, even when you click on them the check mark won't appear on them,

i've tried searching around but couldn't find much information around Lumira Designer, i've tried the below but with no success

Note: the same Report works perfectly on Design Studio. we're Using Lumira Designer V20.3.1

[TammyPowlas]

Hello Jack - one idea is to try the getmemberlist code listed in Reiner's blog and increase the parameter to over 100 - see https://blogs.sap.com/2017/12/21/mysterious-memberlists-in-lumira-designer/ - but performance could be an issue.

[Former Member]

Hi Tammy thank you for the reply,

but this feature was present in design studio V16.3.0, is it missing on the new vesrion or has limitation on Lumira designer? or am i doing missing some option?

because implementing a work around(hack) to get it working on Lumira is counterproductive imo,

again thank you for the reply.

[Former Member]

hi tammy,

can i raise a ticket for this issue? it's espicially frustrating when in design studio it works fine but on lumira this issue still persistis

[TammyPowlas]

Hello - please go to support.sap.com to raise an incident