Skip to Content

Customize the parameter window in Crystal report

Hi,

I have created a small report where I need to scan barcodes of books that I wanted to create a bibliography. For that I created a multiple value parameter , so we can easily scan barcodes . The first barcode scans very well. But when I scan second barcode, it immediately jumps to finish report and not allowing me to enter more data. If I type the barcode (manually) , it works fine. But, when I scan , it causes issue. Is there any way to fix this issue?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • May 13 at 01:28 PM

    If you can set the scanner to not send a RETURN after each scan, that should fix the issue.

    Or create a very simple app to collect the scanner data with a button to then launch the report via a command line. There are several third-party Crystal Reports tools that provide a command line interface.

    Add comment
    10|10000 characters needed characters exceeded

  • May 13 at 06:32 PM

    Hello Ido,

    Thank you so much for your suggestion. I will ceratinly try those.

    Once again thank you so much.

    Mona

    Add comment
    10|10000 characters needed characters exceeded