Skip to Content
0

On passing Idoc Control Param Test as 'X' RCVPOR becomes blank

May 11 at 06:39 AM

18

avatar image
Former Member

Hi Experts,

I am working on Inbound Orders scenario(PI to ECC through IDOC). Scenario is working fine, but if I pass Test flag as 'X' Receiver Port(RCVPOR) is getting cleared in IDoc and I am getting message Inbound Partner Profile does not exist and with status 56.

Following is the payload,

<EDI_DC40 SEGMENT="1">

<TABNAM>EDI_DC40</TABNAM>

<DIRECT>2</DIRECT>

<IDOCTYP>ORDERS05</IDOCTYP>

<MESTYP>ORDERS</MESTYP>

<TEST>X</TEST>

<SNDPOR>TRFCSAPXI</SNDPOR>

<SNDPRT>LS</SNDPRT>

<SNDPRN>XXX</SNDPRN>

<SNDSAD>DEDCLNT400</SNDSAD>

<RCVPOR>SAPDED</RCVPOR>

<RCVPRT>LS</RCVPRT>

<RCVPRN>DED400</RCVPRN>


Thanks and Regards,

Vijay.

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

0 Answers