on 11-13-2008 1:38 PM
Hello everybody,
we've been using the CUA for quite some time and it works fine on all of our systems. Recently we've installed a new NW 7.10 system and I tried to connect it to our CUA. So far, so good. Now I'm trying to create users in our new systems and all I get (in transaction SCUL) is the error "The communication type RML is not defined". In our new system in transaction SCOT there is a RML-node, so it should be defined in general. I've never seen this message and I have no idea how to resolve it.
Any suggestions?
Regards
Mario
Just in case someone else is having this problem, too:
In the end it WAS the mentioned Sapnote 1167877. But it wasn't just implementing it, but also executing the mentioned ABAP report - and voila: It works!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
See if this note is useful for you.
Note 333441 - CUA: Tips for problem analysis
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.