on 11-12-2008 8:44 AM
Hi..
When i try to import the custmized zBAPI it is not showing in the list of RFC's, and when i checked in R/3 system the i can able to see that BAPI and tested that BAPI also..
what might be the problem..
regards
Sai
HI..
The above replies will give the solution but any way..
IN SAP SYSTEM i.e R/3
1. go to SE37
2. Give the Developed ZBAPI name
3. Choose Display
4.You will be see the source code over there choose the ATTRIBUTES Tab there will be 3 options NORMAL FUNCITON MODULE, REMOTE-ENABLE MODULE, UPDATE-MODULE
5. Choose the Remote Enable Module and in update module choose Start Immediately
6. Save the Bapi
7. Activate the Bapi..
8. Go to SAP XI and check it by importing the ZBAPI in RFC..
regards,
Kishore
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
There could be two thing,
1. Check if you have activated the BAPI.
2. Second most import thing as Prateek said, check if you have made the BAPI remote enabled under attribute TAB in SE 37.
Regards,
Sarvesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Check in R3 system that at attributes of your BAPI, it is set as Remote enabled.
Regards,
Prateek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.