on 05-08-2018 9:21 AM
Dear Expert,
is there any std SAP tcode that can perform mass delete dependent characteristic for routing. I try to use CEWB but found out the dependent value is blank, but at CA03 got value. Kindly advice. TQ
Regards,
Hi Mohamed,
Do you want to perform mass Change/ Delete/ Create of Routing in CA03 Transaction Code. You can go for BDC Recordings to do the same.
If further clarifications comment below.
Thanks & Regards,
Niyas
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Mohamed,
I have small clarification, so you wanted to delete the Operation/ Activity Number along with that particular line item, right, as shown below;
For Deletion also we are supposed to go for BDC Recordings. I don't think so there is a T-Code to perform the same.
(Note: In a single program we are supposed to have two recordings, one for Deletion and another for Change or Create recordings)
Hope this helps you.
Thanks & Regards,
Niyas
Dear Niyas,
From your screen to further click on Inspection characteristic.And further screen as below. This is sample for one line item.
characteristic-overview-dependent.jpg
Thanks,
Hi Mohamed,
I have tested your requirement and attached the screen-shots for your reference.
Initial steps as follows:
Enter the T-Code : CA02
Enter the Material Number and Plant
Click on Enter
Select the Line Item and click on Inspection Characteristics
then, followed by click on Select All button as shown below:
Then just click on Delete All as shown below:
Just do the BDC Recording to Delete the Inspection Characteristics.
(Note: Logic is click on SELECT ALL then followed by DELETE ALL then finally SAVE in BDC RECORDINGS)
Hope this clarified your answer.
Thanks & Regards
Niyas
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Flavio,
Thanks for your respond. This is regarding tcode CA03, inside this tcode got Characteristic overview screen and dependent characteristic. We would like to delete all the master inspection characteristic maintained inside dependent characteristic screen. As the volume is huge, we would like to seek is there any tcode that we can use to perform mass delete for these dependent characteristic. TQ
Regards,
Atikah.
Maybe trying with CWBQM (QM: Engineering Workbench) could be successful, instead of CEWB.
Thanks and best regards,
Flavio
User | Count |
---|---|
110 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.