Skip to Content
-1
h k

How to delete Rule: 00 Technical Group; Coding is empty in Transformations?

Hi,

While trying to activate a transformation, it is showing two Technical Groups(00 Technical Groups and 01 Technical Groups) and not able to activate transformation.

How to delete a 00 Technical Group(duplicate) and activate the transformation.

Below is the error Message:

Error @Rule (target: Unknown group: 00 Technical Group): Coding is empty

trfn.png (16.9 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • May 08, 2018 at 10:53 AM

    Hi H,

    I am not sure, but can you please check if this note helps?

    2476800 - 730SP18: Syntax errors during activation of Transformation with End Routine after upgrade

    Best regards, Andras

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Andras,

      Please could you share us the solution to this problem (Error in TRFN)? we are currently facing the same issue while activating the TRFN. Kindly provide us the solution to this error if you have already resolved it.

  • May 08, 2018 at 03:22 PM

    Did you try switching the rule group here?
    Add comment
    10|10000 characters needed characters exceeded

    • Hi Meenakshi,

      I have tried it, it shows 2 Rule Groups: Standard and 01 Technical Group.

      But "00 Technical Group" is not visible anywhere, but while checking for Consistency or activating Transformation, it is showing up in the log.