Skip to Content

Unable to view design time data after putting filter condition

Hi,

I have created a simple data flow where my source is extractor and I want to filter data based on a constant before passing to IBP table.

Data Flow:

Filter written in Target query:


But Design Time Data shows nothing in Output which otherwise shows all the records.




Any comment could prove helpful. Thanks in advance!



hci.png (34.2 kB)
hci.png (20.1 kB)
hci.png (42.2 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • May 07 at 02:45 PM

    Found the reason of the same.

    Sharing so that someone else might benefit.

    There was no output data after putting the filter condition because of the restriction in place for the Sample Data Size.

    To change this, open the Data Flow and click on the icon to configure design time data viewer.

    Add comment
    10|10000 characters needed characters exceeded