Question regarding deltas and filling of setup tables

[Former Member]

Hello Friends,

We are using the Sales Order Item Datasource 2LIS_11_VAITM. We have transported it to BI Production. We have initialized the delta and the deltas are running for the past 3-4 months.

Now we had a new requirement which was getting satisfied by the Sales Order Header and Sales Order Header Status DataSources, 2LIS_11_VAHDR & 2LIS_11_VASTH respectively.

Now we wan to transfer both these (header & header status) DataSources to BI Procution. My question is:

1) Do we have to refill the setup tables again in R/3 for the Sales (11) application?

2) Do we have to reload the entire Sales data again from scratch.

3) Is there any way to transport the 2 new DataSources to BI Production and without disturbing the already running deltas of Sales Order Item Datasource?

Regards,

Prem.

[former_member181964 · Accepted solution]

Hi,

1) Do we have to refill the setup tables again in R/3 for the Sales (11) application?.

Yes you need to refill the setuptables, because if you want to load deltas, you need to do Init then deltas, other wise first time when you are filled setup tables, (first load init with the existing data in setuptables) from that day to till date you can do full then you can set delta.

It is better and good to fill setup tables and load.

2) Do we have to reload the entire Sales data again from scratch.

Any way you need down time to load the other 2 datasources, and also for 11 application you are filling setuptables.So for perfectness it is better to load from first.

3) Is there any way to transport the 2 new DataSources to BI Production and without disturbing the already running deltas of Sales Order Item Datasource?

If you transport the new datasources then delta won't distrub in BW. If you did any changes to DataSource and trying to transport it to production then it will give error, because LBWQ and RSA7 will have data so first you need to clear it and then transport it.

Thanks

Reddy

[former_member205352]

1) Do we have to refill the setup tables again in R/3 for the Sales (11) application?

Ans : Yes you have to.First delete the set up table then refill.

2) Do we have to reload the entire Sales data again from scratch.

Ans : Neednot load to existing header.But you need to do init and later delta to your two new datasources.

3) Is there any way to transport the 2 new DataSources to BI Production and without disturbing the already running deltas of Sales Order Item Datasource?

Ans : Transporting new datasources wont affect existing delta.

Hope this helps.

[Former Member]

Thanks Surendra and Praveen for your prompt replies!!!

Praveen, I wanted to assign full points to you too, but the option was disabled after assigning full points to Surendra. Don't mind. But nonetheless, your suggesstions were equally helpful.

Regards,

Prem.